Integrity Joint: Difference between revisions
From Squirrel's Lair
Ttenbergen (talk | contribs) No edit summary |
Ttenbergen (talk | contribs) |
||
| Line 12: | Line 12: | ||
=== Problems === | === Problems === | ||
fit is too tight | fit is too tight | ||
* last T stem width is 2.9mm | |||
* last T stem width is tenon: 2.9mm; mortise: 2.75mm; diff: 0.15mm | |||
* root of y with is tenon: 3.7mm; mortise: 3.4mm; diff: 0.3mm | |||
* height of first i is tenon: 14.8mm; mortise: 14.9mm; diff: 0.1mm | |||
* height of t is tenon: 14.75mm; mortise: 14.6mm; diff: 0.15mm | |||
* '''avg diff: 0.175mm'' | |||
* is the bit 1.4125 instead of the 1.5875mm it should be? | |||
* test cut single line with 1/16 bit and measure what it really is{{TD Possum Lodge}} | |||
* re-test cut the lettering with bit size set to 1.4125mm | |||
=== To do === | === To do === | ||
Revision as of 14:55, 2013 January 19
A mix between a tenon joint and a statement.
a word is both the through-tenon and the mortise for a joint.
Progress
- word graphic designed such that the inner and outer radius should be big enough for router bit
- Font for inside and outside CNCing in inkscape
- export as .eps (for consistency)
- imported to Partworks 3.0
- cut on shopbot
Problems
fit is too tight
- last T stem width is tenon: 2.9mm; mortise: 2.75mm; diff: 0.15mm
- root of y with is tenon: 3.7mm; mortise: 3.4mm; diff: 0.3mm
- height of first i is tenon: 14.8mm; mortise: 14.9mm; diff: 0.1mm
- height of t is tenon: 14.75mm; mortise: 14.6mm; diff: 0.15mm
- 'avg diff: 0.175mm
- is the bit 1.4125 instead of the 1.5875mm it should be?
- test cut single line with 1/16 bit and measure what it really isTemplate:TD Possum Lodge
- re-test cut the lettering with bit size set to 1.4125mm
To do
- figure out
- buy new 1/16 bit ; I did, where did I put it?
|
{{{1}}} |
|
- make it on ShopBot
File Location
stick\projects\Integrity Joint
