Integrity Joint: Difference between revisions
Ttenbergen (talk | contribs) No edit summary |
Ttenbergen (talk | contribs) No edit summary |
||
| Line 5: | Line 5: | ||
==Progress== | ==Progress== | ||
* word graphic designed such that the inner and outer radius should be big enough for router bit | * word graphic designed such that the inner and outer radius should be big enough for router bit | ||
* [[Font for inside and outside CNCing]] in inkscape | |||
* export as .eps (for consistency) | |||
* imported to Partworks 3.0 | |||
* cut on shopbot | |||
=== Problems === | |||
fit is too tight | |||
* last T stem width is 2.9mm | |||
=== To do === | === To do === | ||
* figure out | * figure out | ||
* buy new 1/16 bit ; I did, where did I put it? {{TD garage}} | * buy new 1/16 bit ; I did, where did I put it? {{TD garage}} | ||
* make it on [[ShopBot]] | * make it on [[ShopBot]] | ||
==File Location== | ==File Location== | ||
stick | stick\projects\Integrity Joint | ||
[[Category:In-process projects]] | [[Category:In-process projects]] | ||
[[Category:InkScape]] | [[Category:InkScape]] | ||
[[Category:ShopBot]] | [[Category:ShopBot]] | ||
Revision as of 12:51, 2013 January 19
A mix between a tenon joint and a statement.
a word is both the through-tenon and the mortise for a joint.
Progress
- word graphic designed such that the inner and outer radius should be big enough for router bit
- Font for inside and outside CNCing in inkscape
- export as .eps (for consistency)
- imported to Partworks 3.0
- cut on shopbot
Problems
fit is too tight
- last T stem width is 2.9mm
To do
- figure out
- buy new 1/16 bit ; I did, where did I put it?
|
{{{1}}} |
|
- make it on ShopBot
File Location
stick\projects\Integrity Joint