Integrity Joint: Difference between revisions
Ttenbergen (talk | contribs) |
Ttenbergen (talk | contribs) |
||
| Line 7: | Line 7: | ||
* [[Font for inside and outside CNCing]] in inkscape | * [[Font for inside and outside CNCing]] in inkscape | ||
* export as .eps (for consistency) | * export as .eps (for consistency) | ||
* imported to | * imported to [[PartWorks 3.0]] | ||
* cut on | * cut on [[ShopBot]] | ||
=== Problems === | === Problems === | ||
| Line 22: | Line 22: | ||
* test cut single line with 1/16 bit and measure what it really is{{TD Possum Lodge}} | * test cut single line with 1/16 bit and measure what it really is{{TD Possum Lodge}} | ||
* re-test cut the lettering with bit size set to 1.4125mm | * re-test cut the lettering with bit size set to 1.4125mm | ||
==File Location== | ==File Location== | ||
Revision as of 13:56, 2013 January 19
A mix between a tenon joint and a statement.
a word is both the through-tenon and the mortise for a joint.
Progress
- word graphic designed such that the inner and outer radius should be big enough for router bit
- Font for inside and outside CNCing in inkscape
- export as .eps (for consistency)
- imported to PartWorks 3.0
- cut on ShopBot
Problems
fit is too tight
- last T stem width is tenon: 2.9mm; mortise: 2.75mm; diff: 0.15mm
- root of y with is tenon: 3.7mm; mortise: 3.4mm; diff: 0.3mm
- height of first i is tenon: 14.8mm; mortise: 14.9mm; diff: 0.1mm
- height of t is tenon: 14.75mm; mortise: 14.6mm; diff: 0.15mm
- 'avg diff: 0.175mm
- is the bit 1.4125 instead of the 1.5875mm it should be?
- test cut single line with 1/16 bit and measure what it really isTemplate:TD Possum Lodge
- re-test cut the lettering with bit size set to 1.4125mm
File Location
stick\projects\Integrity Joint