Laser Cutting: Difference between revisions
From Squirrel's Lair
Ttenbergen (talk | contribs) |
Ttenbergen (talk | contribs) |
||
| Line 22: | Line 22: | ||
=== Tweak and put into files instead === | === Tweak and put into files instead === | ||
{{TD Possum Lodge}} | {{TD Possum Lodge}} | ||
retest and save in settings if best | |||
* Styrene "use low frequency like 30 but high speed" | * Styrene "use low frequency like 30 but high speed" | ||
** 10sp 30pw 40fr worked; could prob go faster | ** 10sp 30pw 40fr worked; could prob go faster | ||
== URLs == | == URLs == | ||
Revision as of 08:39, 2012 November 20
75 watt epilog laser cutter
workable materials
- Laserable materials: http://www.epiloglaser.com/laserable_materials.htm
- for plastics:
Material size
- 18" by 24" (aka 45.72cm x 60.96cm)
eliminate the "fog" around things
Alexander's calgary flames had a fog around them - why? when looking how to print from Inkscape I found some info about this... some people called it a "halo"; didn't find out what the solution is.
Materials/Speed/Power settings
see Laser_cutting_test_settings for tool to facilitate
see stick\Tools\Laser\Laser cutter settings for tested settings
Tweak and put into files instead
Template:TD Possum Lodge retest and save in settings if best
- Styrene "use low frequency like 30 but high speed"
- 10sp 30pw 40fr worked; could prob go faster
