Jump to content

Wood inlays: Difference between revisions

From Squirrel's Lair
← Older editNewer edit →
VisualWikitext
Ttenbergen (talk | contribs)
admin, Bureaucrats, Interface administrators, smwadministrator, smwcurator, Administrators
3,931 edits
No edit summary
Ttenbergen (talk | contribs)
admin, Bureaucrats, Interface administrators, smwadministrator, smwcurator, Administrators
3,931 edits
No edit summary
Line 1: Line 1:
Raster the area, cut the shape from veneer...
Raster the area, cut the shape from veneer...


Is the laser line thin enough not to worry about it?
see [[Adjusting for kerf size in inkscape]]
* works with same settings, may be better with a 1px inset, need to see after I finish off the test setup I made
* someone mentioned about a .25mm cut line on an epilog
 
[[File:Veneer cut line test.jpg|300px]]
 
 
Using about 0.20mm dynamic offset to compensate for kerf produces tight fit.


[[File:Laser_cut_inlay_walnut_on_oak.JPG|300px]]
[[File:Laser_cut_inlay_walnut_on_oak.JPG|300px]]

Revision as of 19:47, 2012 November 23

Raster the area, cut the shape from veneer...

see Adjusting for kerf size in inkscape

Retrieved from "https://wiki.squirrelslair.ca/index.php?title=Wood_inlays&oldid=473"