Wood inlays: Difference between revisions
Ttenbergen (talk | contribs) No edit summary |
Ttenbergen (talk | contribs) No edit summary |
||
| Line 7: | Line 7: | ||
[[File:Veneer cut line test.jpg|300px]] | [[File:Veneer cut line test.jpg|300px]] | ||
Using about 0.20mm dynamic offset to compensate for kerf produces tight fit. | |||
[[File:Laser_cut_inlay_walnut_on_oak.JPG|300px]] | [[File:Laser_cut_inlay_walnut_on_oak.JPG|300px]] | ||
[[Category: Laser cutting]] | [[Category: Laser cutting]] | ||
[[Category:Portfolio]] | [[Category:Portfolio]] | ||
Revision as of 17:59, 2012 November 23
Raster the area, cut the shape from veneer...
Is the laser line thin enough not to worry about it?
- works with same settings, may be better with a 1px inset, need to see after I finish off the test setup I made
- someone mentioned about a .25mm cut line on an epilog
Using about 0.20mm dynamic offset to compensate for kerf produces tight fit.
