Wood inlays: Difference between revisions
Ttenbergen (talk | contribs) No edit summary |
Ttenbergen (talk | contribs) No edit summary |
||
| Line 1: | Line 1: | ||
Raster the area, cut the shape from veneer... | Raster the area, cut the shape from veneer... | ||
Is the laser line thin enough not to worry about it? | Is the laser line thin enough not to worry about it? | ||
* works with same settings, may be better with a 1px inset, need to see after I finish off the test setup I made | * works with same settings, may be better with a 1px inset, need to see after I finish off the test setup I made | ||
* someone mentioned about a .25mm cut line on an epilog | |||
To do: | To do: | ||
* finish the test case | * finish the test case | ||
* picture and upload {{TD computer}} | * picture and upload {{TD computer}} | ||
| Line 11: | Line 13: | ||
[[Category: Laser cutting]] | [[Category: Laser cutting]] | ||
[[Category: | [[Category:Portfolio]] | ||
Revision as of 13:20, 2012 November 12
Raster the area, cut the shape from veneer...
Is the laser line thin enough not to worry about it?
- works with same settings, may be better with a 1px inset, need to see after I finish off the test setup I made
- someone mentioned about a .25mm cut line on an epilog
To do:
- finish the test case
- picture and upload
|
{{{1}}} |
|