Edit Project: Electric Outboard Conversion Gearbox Adapter Plate

You do not have permission to edit this page, for the following reason:

The action you have requested is limited to users in the group: Users.

Short Description:
Long Description:	A customer was updating an outboard motor from gas powered to electric. They wanted to re-use the old gearbox and propeller shaft, so they needed an adapter plate to top off the old bottom-end and mount the electric motor on top. We [[3D Scanning\|3D scanned]] the top of the old motor, turned the point cloud into a parametric model using [[Geomagics DesignX]] re-engineering software. The customer then had the part milled based on the model.
How we did it / geekery:
Skill Set:
Project Type:
North Forge Fabrication Lab:

Free text[edit | edit source]

[[File:Electric Outboard Conversion Gearbox Adapter Plate Closeup.jpg | 300px]] [[Category:3D Scanning]] [[Category:Reverse Engineering]] [[Category:3D Modelling]] [[Category:Prototyping and Integration]]

Summary:

Cancel